Tab width options

Suggestions and feature requests.
Post Reply
Message
Author
Forez
Posts: 388
Joined: 30.01.2016, 11:05
Location: In front of a PC monitor

Tab width options

#1 Post by Forez » 01.11.2016, 19:25

I would like to propose adding these option, concerning the subject of how wide the tabs are:


1] One overall tab width, set be the user, applied to all tabs. If some length folder is wider and there is no room to display it, then if will simply be shown partially

2]
One overall tab width, set be the user, applied to all tabs. But if the length folder is wider and there is no room to display it, then make than particular tab wide enough [and wider any other tab that needs doing so, each accordingly to it needs]

2A] Including locked tabs

2B] Excluding locked tabs

3] One overall tab width, set be the user, applied to all tabs. But if the length folder is wider and there is no room to display it, then make all tabs the same width [wide like the widest]

3A] Including locked tabs

3B] Excluding locked tabs

4] All tabs as wide as the widest one of the locked ones


+ The current behavior

Forez
Posts: 388
Joined: 30.01.2016, 11:05
Location: In front of a PC monitor

Re: Tab width options

#2 Post by Forez » 04.11.2016, 08:04

And one of the reason would be, to give the user an overall option for a quick closing of unwanted tabs, when a long workflow results in creating many tabs; by clicking in the same spot of screen

Post Reply

Who is online

Users browsing this forum: No registered users and 7 guests