Page 1 of 1

672 - Recently used values in "Go To Folder"

Posted: 02.10.2014, 14:14
by larsen
When I open the "Go To Folder" dialog with Ctrl+G, enter "c:", I think FC used to instantly display one of the last folders with that beginning.
Now, I first have to press Cursor Down to get that proposal.

Is my memory correct? Is this supposed to be this way or has it changed?

Re: 672 - Recently used values in "Go To Folder"

Posted: 27.02.2015, 14:20
by larsen
*push*

Re: 672 - Recently used values in "Go To Folder"

Posted: 27.02.2015, 18:43
by Timon
Yes, behavior was changed due to a large number of complaints for not quite correct proposals (everywhere in FC XE - also in "New folder" and so on). But I don't know where it could be changed (personally, I like new behavior).

Re: 672 - Recently used values in "Go To Folder"

Posted: 28.02.2015, 10:18
by larsen
Is there a way to configure this behaviour in the options?

Re: 672 - Recently used values in "Go To Folder"

Posted: 28.02.2015, 18:42
by joby_toss
Not that I know off...

Re: 672 - Recently used values in "Go To Folder"

Posted: 28.02.2015, 20:54
by larsen
Where can I post a feature request? ;-)

Re: 672 - Recently used values in "Go To Folder"

Posted: 28.02.2015, 22:41
by joby_toss
Here ;)

Image

Re: 672 - Recently used values in "Go To Folder"

Posted: 01.03.2015, 08:16
by larsen
thx =)

Re: 672 - Recently used values in "Go To Folder"

Posted: 01.03.2015, 09:20
by larsen