FreeCommander Forum

This behavior, which I described in the thread at - viewtopic.php?t=10628 - which was fixed with the release of 822, has returned as of my update to 826 this morning from 825.

Again, with desktop folder open in a tab in the left pane, and various folders inside my OneDrive open in tabs in the right pane, if I select a tab on the right, navigate into a subfolder, move a file from the desktop into this folder via the red center toolbar button, and then go back up to the tab's original top folder, (via clicking on the ".." folder, or clicking on the path, etc) the contents of the pane update to the contents of the correct folder, but the name of the tab does not update (it still says the name of the previous folder).

I have just now reverted back to 825, confirmed that this bug was still "fixed" in 825, and will wait until 827 is available to check again.

Thanks!

Just upgraded from 825 to 827, found that this bug still exists in 827, and then again downgraded back to 825 which fixed it.
Thanks!

Please try to use the portable version - no install needed and your installed version works too.
Try to define steps to reproduce the problem. If possible not with OneDrive folders.
It would be helpfull if you could send me some screenshots.

Okay, so I grabbed the 828 portable and have found the bug continues in 828.

Reproducing the bug, as shown in the screenshots at https://imgur.com/gallery/TtHZ0eS
1. Launched 828 portable (freshly unzipped from downloaded zip file)
2. changed both tabs display to column view
3. navigated to the desktop folder on the left and a folder within my documents folder on the right
4. opened file destination folder on the right
5. selected file to move in left (desktop) tab, about to click move
6. move of file complete
7. now about to double click the "dotdot" folder to go back up one level
8. result of move up action - tab on right shows correct folder contents but name of tab is still showing the last folder.

Thanks

I finally got around to testing since the release of 829 and can now confirm that while I can reproduce this 'tab name not updating' bug in releases 826, 827, and 828, I have not been able to or seen it happen in 829! Thank you so much!