Add full path dispaly to tabs

[soiee]

The only solution to show the full path of a tab as of now seems to be hovering the mouse on a tap then the full path will show. But often I have dozens of tabs and hovering my mouse on each of them takes a quite amount of time. I suggest adding the full path display feature to the pull-down list as shown below.
[img][https://drive.google.com/file/d/1ELGZT- ... drive_link]

Before the suggested feature is approved and added, a workaround might be to shorten the delay time between hovering and displaying. Is there a setting to set the hovering delay?

[Karol]

Try to use Ctrl+PgUp

[Forez]

I personally do not have such a need nor will not in a foreseeable future - but I sure can imagine scenarios where such ability would be desired; and thus I support it

[soiee]

Try to use Ctrl+PgUp

This works - only on one pane Here is what I tried:
1. On one of my two computers, ctrl pgup works fine w/ the right pane of the FC but shows a very long delay w/ the left pane which makes it literally usable. BTW, I normally use the two-pane layout for my FC.
2. On my other PC, this combination doesn't work on both panes.
Any tips? I checked the shortcut setting but wasn't able to locate a relevant entry.

[soiee]

I personally do not have such a need nor will not in a foreseeable future - but I sure can imagine scenarios where such ability would be desired; and thus I support it

[rocco_lampone]

@soiee, one more option would be to go to View --> Show --> Show command Line
Once enabled, you would see the full path of the active tab at the bottom. And since the command bar is common to both tabs, almost the entire screen width is available to show the path.
Even when you switch tabs the path gets updated.

Hope this helps.